Went with this swivel after reading lots of guidance. Very pleased with the results. Easy to install on the lowered bases and to connect to the seat. Wiring isn't too bad, just go slowly and then re-tie or tape everything under the base. I was able to get the jack toolkit to fit back under the passenger side. The swivel squeaked a bit at first as the latch detent etched it's circular path. I applied a little lithium grease (could reach it with a Q-tip) and that addressed it. Went ahead and put the same base and swivel on the driver's side.
Reviewed by: Chris from CHARLOTTE, NC.
I installed the passenger side swivel on a Promaster hightop 2500. Easy install. The hole in the center is large enough to pass the connector through without taking it apart. Increases seat height about an inch and a half. Be aware of the actuating lever, which sticks out into the aisle a bit. My wife catches her leg on it often. Can swivel just fine without opening the door. Absolutely norattles or looseness when locked into travel position.
Reviewed by: bcblues from America's Outback.
Poor QC, Damaged Lever
Response from Customer Service, EuroCampers.com - We test and inspect every ProMaster swivel adapter before it ships. We test the operation, we thread all the bolts and we repack the swivel in a new box with blocking to protect from damage. The damage described in this review could only have happened during shipping. This type of damage should be reported promptly and a replacement swivel can be shipped out. "2 years ago I purchased the driver side swivel & finally decided to get one for the passenger side seat. I mounted it to the seat base before noticing that the swivel lever was damaged. It was bent to the extent that the swivel couldn't be actuated until I took a crow bar & pried it away from the turntable. Prying probably wasn't a great idea because the lever wanted to pull out from the mechanism rather than bend outward. But I was able to make it work. Along with the bent lever, the rubber-like protective grip was badly damaged. It was driven well down the lever leaving the metal
end exposed. I can't believe that I didn't notice these defects until I was placing the seat on top of the swivel, but that was probably because I'd had experience installing these so I wasn't paying a lot of attention. Rather than removing it from the base & returning it I decided to complete the installation. I inspected the box it arrived in & found no damage so it appears obvious that the damage to the lever & grip occurred prior to it being packaged for shipment. At this price I expect better. I have pics but regrettably this site doesn't allow pics with reviews."
Reviewed by: Bill from FLORENCE.
Easy to install and a instant upgrade! It’s so nice to have more usable space when the seat is turned around. Highly recommend!
Reviewed by: Jay from North Carolina .
This item arrived quickly, I was on a wait list as they are often out of stock but once some came in, it was shipped right away.
It took me about an hour to install. The screws they include to attach this item and replace the factory screws are, in my opinion, much better. The front factory screws were difficult to remove as the seat does not slide back far enough to get a clear area to work on the screw. The Allen wrench you use with the swivel works much better.
The hole in the swivel is big enough to take the three plastic connections you have to use. I would buy the swivel again, right now I am only using it on the passenger side. Not cheap but a very good product.
Reviewed by: Ron Paris from Kingston ON Canada.