Replacement thermostat for EuroVan Camper Furnace

Does exactly what it says - I like the updated look and the furnace cycle times are reduced. Notes: 1) I was able to use the existing mounting holes, but the ring terminals were just barely too large to fit through the new thermostat. I bent them to get into place and then restored. The other option would be to drill out the plastic holes by a few mm's. 2) It took me way too long to figure out which wire went where. Ultimately I'm not sure it matters as this is a simple on/off switch. 3) It's slightly less convenient to have the temp set at the top, but this is a small gripe that is probably irrelevant.

The thermostat works well, though it does leave visible two holes that I needed to get putty to hide. I like have the indoor thermostat that is part of the unit.