Thin-Lite 12 volt 13" LED Light Fixture - replaces 1995 - 2003 EuroVan Camper Fluorescents

The original fluorescent was fine, but wanted an LED to reduce battery drain. This has 2 light levels - perfect. A bit tricky to install, though. Not much room in fixture for wire connection and no room above fixture (plastic backed by solid sheet steel) On original light, note which wire is hot (there is a label on fixture) and then match with hot wire on new fixture - they are different colors

This light works great, it's brighter and draws less battery power. The light is narrower than the factory unit so it may not cover the previous holes in the ceiling. I used the base piece of the old light to cover the holes and then attached the new light to the old base. It gives it a better cosmetic look.

We have a 1995 Eurovan and these lights are a great upgrade. The only issue was that the light didn't cover the hole so I had to install a cover. Highly recommend.

Better light, everyone had great points. Cut the base off the old one and put the new light on top. It’s a more finished look which is irks because of you don’t you’ll see the cut out section. Definitely worth the save price. I got led’s all around and can’t be happier with the enhanced lighting.

As others have mentioned, this is a nice upgrade from the original CFL galley light. I really like the soft on/off and two stage brightness control. By holding the switch it can also be set to a custom brightness level. Three installation notes: 1) The size and position of mounting holes is different from original. This requires some creative problem solving. You can reuse one of the screws but the other will be too long. 2) The wires are long, and can bind if not trimmed. They also run directly behind the mounting holes, causing a risk of puncture while installing. 3) The housing end caps are held on with the tiniest screws I've ever seen. Be careful not to strip them.